1 / 7
C03 camera holder for old Mobula6 canopy
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lightweight, no screws, no sticking out lens, fixed angle.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 58
- Makes
- 0
- Views
- 563
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Standard Digital File License
Uses Phoenix-Prints' design:
https://makerworld.com/en/models/938312#profileId-903531
Needs a lot of supports, organic are not too annoying to remove.
Version on pictures is 30 degrees.
UPD: I've been using it almost daily for months now and the only issue is that when you throttle into the ground inverted it's a little too harsh for the camera. I broke off two IR filters this way and started putting a little bit of foam between the top of the camera and canopy.