Parametric hobby horse holder with table clamp
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€10.34 – €12.63 net (excluding VAT)
For file: Hobby_horse_stand_and_clamp_0.4n_0.2mm_PETG_MK4S_10h1m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €11.49 excluding VAT (range midpoint).
- Weight reported by the author
- 187 g
- Print time reported by the author
- 10.01 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Parametric hobby horse holder mountable on a table with clamp
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 98
- Makes
- 0
- Views
- 571
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Cosplay & Costumes in general
- License
- Creative Commons — Attribution — Share Alike
Parametric hobby horse holder based on a design from @Wejrice but since the one of the screw holes was off, I completely redid the model in OpenSCAD. I added a table clamp by 247generator which I extended by a bottom part, cleaned up and added threaded inserts for joining the parts.
It should be easily printable without supports (the clamps need to be printed twice). I used PETG, 0.2mm layer height, 0.4mm nozzle. Around the inserts I used 100% infill, if you use the *.3mf, it's set up already.
Feet of the clamp may be printed in FLEX.
To join the holder and the clamps, you can either:
- put 4 threaded inserts into the clamps and then use 4xM3 screws (length approx. 6 mm).
- make the holes in the clamps smaller and just screw them into plastic.
- just glue the parts together
- Screw the holder to some other surface (e.g. a wall).
Threaded inserts used are: https://www.prusa3d.com/en/product/threaded-inserts-m3-standard-100-pcs/.
Note: the pictures are of the original holder, the one attached has a different (but similar) horse image.
Updated 2025-01-11: thicker stand + chamfered hole + variants with 1, 2 or 3 holes.