Drillbit screw case holding 37 bits
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for 37 metric screw bits (~6mm hex L~25mm). Satisfying six start thread, less than 45° twist to open with click.
- Rating
- 4.667 / 5
- Likes
- 35
- Downloads
- 205
- Makes
- 6
- Views
- 890
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
When browsing for stls for a bit case I found a number of cases with a threaded lid, however I found that most used a normal thread, meaning it was necessary to twist a number of turns to open. This version have a six-start thread, meaning that the case is very quick to open. There is a notch at the end to give a sort of tactile feedback when the case is twisted close.
Three parts are included, the Bottom and Top part of the case and also the “Bit raster”-part, so without the raster, the case can be used for other things than bits.
Optionally, magnets can be glued to the bottom of the bit raster part, I tested this but found out that the magnets need to be rather strong and close together to hold the bits safely, think neodymium/super magnets. There are 3mm space between the bottom of the case and the bit raster.
The parts are optimized for 0,45 mm extrusion width.