1 / 4

Archetype Apus2 Extruder Block

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Breakneck compatible Archetype extruder adapter for use with the Phaetus Apus 2 extruder w/ tool board mount.

Updated at source: Jul 30, 2026

Model information

See the updated version with PUG mount here:

Print model as is, Voron standard settings.

The tool board contains a modifier mesh. For better tool board air flow please use the following settings with the modifier:

Part	Quantity	Part	Notes
m3x8mm SHSC	2	Tool board	Holds tool board to mount
m3x40mm SHSC	1	Tool board	Holds tool board mount to extruder
m3x4x5mm heat-set insert	4	Tool board	Interface with screws
Short piece of .032 Piano Wire (~30mm)	1	Tool board	Cable strain relief
1x2mm ziptie	1-3	Toolboard	Cable strain relief
m3x5mm BHSC	1	Extruder	Holds extruder to adapter on right side
m3x8mm BHSC	3	Extruder/Toolboard	Holds extruder to adapter on left and top Secures toolboard clamp to toolboard mount

Attach the Apus 2 to the adapter using 2 m3x8 on the slightly thicker base holes, and the m3x5 on the other. (see photos)

Assemble the extruder block and rest of Archetype as normal.

If using the tool head board mount:

Insert the heat set inserts
Insert the piano wire into the provided hole
Remove the Apus 2 face plate
Attach the tool board mount to the Apus 2 using the m3x40, replacing the existing screw. Take care snapping the arm into place.
Attach the tool board with the remaining two m3x8 screws using the printed spacers in between the PCB and mount.
Wire up the tool board.

Added a clamp to secure the top point of the tool board so it does not shake around.