10" inch rack shelf for server/PC Qotom series Q203* in New design (for example Qotom Q20331G9)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Shelf for 10" rack home lab server series Qotom series Q203* in New design (for example Qotom Q20331G9)
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 61
- Makes
- 0
- Views
- 841
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
Shelf for home server series Qotom Q203* in New design (for example Qotom Q20331G9).
! Check your stand carefully before printing - tray width 228mm! For wide stands!
I just received a new Qotom Q20331G9 server for my home lab. The width is incorrectly stated by the seller in the new design - the actual width-depth dimensions are 220x122mm (he states the width as 217mm). I made this shelf for my 10" rack.
Don't make the same mistakes I did - clean the support area thoroughly after printing, mine slightly cracked the back partition on one side, but it fit tightly. It was subsequently cleaned and sealed.
In the latest iteration, the server was modified and the power button was moved to the panel with network connectors (Dupont 2.0mm pins).
Recommended print settings (I printed on a Creality K1C, so I adapted the design for vertical printing on its table):
1. I prepared the project for printing in OrcaSlicer - total print time ~6.5 hours with 100% Infill.
2. PETG filament.
3. Brim type - Auto (was on, the model did not come off - check after slicing).
4. Supports: Tree (Auto) - Tree Slim. Threshold angle - 10.
Good luck with printing.