1 / 2
Z-Top Idlers for Voron 2.4
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacing the original Z Idlers on Voron 2.4 with this model
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 47
- Makes
- 0
- Views
- 488
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Introduction
I noticed a deformation of the belts. It's moving forwards causing the belt to be a few millimetres out of alignment. Consequence: the Z height cannot be respected without a correction in klipper (with distance_rotation).
My model makes it possible to correct this phenomenon.
Tightening the screw from above to tension the belt is much easier than from below.

BOM
Printed parts
- 4x
[a]_z-top_tensioner_9mm_x4 - 2x
z-top_tensioner_bracket_a_x2 - 2x
z-top_tensioner_bracket_b_x2
Hardware
- 4x GT2 20T Idler Gates 9mm
- 8x BHCS M5x20
- 4x Nut M3
- 4x SHCS M3x16 or 20 or 22 or 25 for what your needs (min 16 / max 25)
Print settings
- Filament type : ABS
- Infill : 40%
- Layer height : 0.2mm
- Support : without
Slicer

Please let me know if you have any comments 😎
Enjoy !