Card Deck Box TCG Vault X Adjustable Spacer / Screw / Divider / Twist Jack / Gap Filler

Adjustable Card Spacer

I made this adjustable spacer so you can make sure your cards sit upright at all times.

It's basically two plates that attach to a screw and threaded barrel at either end.
You pop the plates into your box and expand the screw/barrel between them to lock them in place.

Quick Points

• It can adjust between the screw length (~75mm) up to double it's length (~150mm).
• The plates sizes for a VaultX cardbox (84x83) as well as a smaller off-brand box (70x48) has been uploaded.
• The raw Fusion360 file is also included so you can change the “height” “width” “length” user parameters to quickly create other sizes as you like.
• Please upload remixes if you modify/create new sizes for others without Fusion :)
   

How to print

1. Download the plates that match the size of your card box.
2. Download the shaft, and screw with the length you want (i.e 75mm)
3. Print!
   I have already included a tolerance of about .75mm in the models.
   It prints great on a Bambu mahine in PLA without modification.
   
   Print settings:
   - No supports needed.
   - 0.2 mm or smaller.
   - Enable “Precise Walls” for better results.
   
   If you have a multi-color machine I advise using a diferent color for the last 3 turns of the screw thread. This will help you see when you are near the end of the thread.
    

Need a diferent size?

You can request a size and I'll get it uploaded, or you can grab the Fusion file and change it yourself. The parameters you want to change are:

• “height” - plate height
• “width” - plate width
• “length” - screw/barrel length
   

Screw slipping / tolerences issues?

If your tolerances are:

• loose / slipping: you can print the “NUT” file to keep it in place.
• tight / hard to turn: you will have to dail in the machine, or try adding a bit of vaseline to the screw. Tbh you should probably lube the screw anyway.