Filament Cutter for Ratrig Toohead V1 Vcore3.1 Upgrade version
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a filament cutter for the RRV1 Toolhead upgrade version for VC3.1. It has a beacon H mount
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 95
- Makes
- 0
- Views
- 707
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
***Update January 16 2025 Revised “Back” STL file to improve the tie wrap holes at the bottom to secure the beacon cable. The holes are larger and more robust.
***Update January, 15 2025 Revised "Back" STL file to improve thin wall issues in two places. Updated step file with same changes
***Update January 13, 2025 The “front” print was missing the recesses for the two screws that mount the orbiter and have been added. If you've already printed it, you could add the recesses with a drill or re-print. Sorry for the inconvenience. I have also updated the step file accordingly.
This is a filament cutter for the ratrig toolhead v1 upgrade for vcore3.1 systems. This is remixed off of the ratrig files, as well as my own design and also I modified both files from Logibear's design: https://www.printables.com/model/932078-rat-rig-toolhead-10-duct-and-fan-mount-for-beacon
This toolhead was also changed to accept the beacon revH as well as removes support for the super pinda. This toolhead is based off of the toolboard version and requires an EBB42
Check the step file for all hardware requirements. It uses much of the same hardware (including the spring) as my previous ratrig toolhead beta2 filament cutter found here: https://www.printables.com/model/695543-ratrig-toolhead-v1-beta2-filament-cutter
And for more information see my original filament cutter here: https://www.printables.com/model/647352-filament-cutter-for-eva3-orbiter-rapido You could use the servo actuator used for this design, although it may have to be slightly modified.
The lever will need supports. Lay it on it's flattest side and support the remaining portion and the (now upper) wall in the blade mount socket. Clean up the supported faces well so they operate smoothly against the lever and blade mounts.
IMPORTANT: Specify X offset of zero, and Y offset of 17.5mm for the beacon. This is different than the stock V1 toolhead for the VC4