1 / 6
K1C Hotend adapter for Ender 3 (MK8 Heatsink) — image 1
1 / 6

K1C Hotend adapter for Ender 3 (MK8 Heatsink)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adaptor to use the K1C hotend with MK8 style heater block printers. Ender (3, 3 pro, V2), Ender 5(pro), CR10, etc.

Rating
0 / 5
Likes
16
Downloads
56
Makes
0
Views
913
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

Started on this project because I was too cheap to buy a Revo CR for my Ender 3.  Was looking for a cheap solution for a quick cold swap hotend that could put out more than the stock flow of a Ender 3 Microswiss all metal hotend. Saw on amazon that the legit Creality K1C hotend was $30 which came with the hot end, a 0.4 unicorn nozzle, and the upgraded heat sink as well as a universal nozzle wrench and various allen wrenches. Built this around my Ender 3 V1 which has a Micro Swiss direct drive all metal extruder and a StealthySwiss fan shroud(Frankenstiened Stealthburner/ Microswiss design by RomaAquatics). If you choose to copy my build use the Creality Spider Base for Stealthy Swiss by Snokryptic612 on Thingiverse. I removed the fin design in front of the hotend fan as it was creating too much backpressure on my noctua fan.  

This adapter keeps the stock nozzle x, y, and z distance and prints with no supports needed. You will need to sand or file a mm or so of the back fins of the aluminum heatsink for fitment. Make sure to take the hotend parts off when you do this else you will likely end in a ruined thermistor wire like me and have to wait on a new hotend ($12ish) or buy a new thermistor ($11ish).

You will need to reuse the two m3 x 18 screws that hold your stock heatsink a couple of m3 nuts, and a x2 small button head m3x10 screws. Attach the m3 nuts or use the version with voron m3 heat inserts, I used precision screw driver with smaller allen driver, you can also use a soldering iron if your nuts are too tight and not fitting. Fix the adapter to the backplate with the smaller button head m3 screws, then slide the K1C hotend up into the adapter and attach with the m3x18 screws. PTFE tubing should be a tight snug fit and should meet up with the back of the heatbreak.  For the wiring you will need a 2.5mm (for the heater) and 2.0mm( for the thermistor) JST crimpset. You can also get away with a 2 pin male dupont for the thermistor, but I would put heatshrink on it to keep it attached. New nozzle may smoke a little on first use as it burns off any factory oils. 

This is the hot end assembly I used. At the time was on sale for $30 https://a.co/d/6OQ9krC

Please feel free to remix this! 

 

Tags