V1 - Presonus EarMix 16M & Sennheiser SR IEM G4 Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Attaches an EarMix 16M to the top of an SR IEM G4 transmitter using magnets.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 12
- Makes
- 0
- Views
- 162
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial
Check out the V2 model here: https://www.printables.com/model/1330744
---
Secures the Presonus EarMix 16M IEM controller to the top of a Sennheiser SR-IEM-G4 transmitter with magnets!
Required Materials:
8x: 6x3mm magnets
4x: 3x8mm flat head screws
---
This is effectively a V1 model, if I were to update it, it would either use larger magnets or some other system to attach the two together with. These magnets work decently for holding it in place, but they are not as strong as I would wish. I did however use Amazon magnets, so take that as you will for their strength.
Supports aren't necessarily required for the SR-IEM adapters, I ran it with automated tree support to make sure the holes didn't sag, but I've since learned that you make horizontal holes a teardrop shape to account for that issue - I instead made them octagons.
To account for horizontal forces, there are alignment brackets that can be printed for the rear two connectors. These can be glued to the upper portion of the alignment bracket. All it does is keep the rear connectors attached to the EarMix from sliding off the back or too far to the side.
---