Blushd = Blush + Lush Hybrid (Crush/Rush remixes) = Diana Mag Crush!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Blush/Crush but for the Diana mags using a merged Lush mag well
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 45
- Makes
- 0
- Views
- 769
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Currently non-functional pending pusher updates. The Diana feed lips are much tighter than Talon mags. Will likely use ½" brass pusher.
Print all files from Blush except for Lower, Mid Body, Mag Release, and Ram Body. Print all three Lush Mag Release parts.
Hardware:
Lush Mag Release: Uses 2x m2.6 nerf screws, and a m3x15 screw (with the existing mag release spring)
Blush Additional hardware:
qty 1: M3 x 8 for the fourth attachment point on the rear cap
qty 2: M3 x 12 (or longer) screws for adjustment wrench
qty 3: 6-32 x 11.1" threaded rod. Just buy a 12" piece and cut it down after things are threaded in.
qty 5: m3 brass insert
qty 1: 60mm length of 9/16" brass.
qty 2-3: -016 o-ring for barrel sealing and alignment.
qty 1: -113 o-ring for pusher seal.
For remaining HW fallow Crush notes.