1 / 2
Paterson reel for 4x5 inch / 9x12cm in 2-reel tank — image 1
1 / 2

Paterson reel for 4x5 inch / 9x12cm in 2-reel tank

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Allows development of 4x5 film in a 2-high paterson tank with 500ml of solution without damaging the film.

Rating
0 / 5
Likes
14
Downloads
111
Makes
0
Views
564
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

How to use : 

  • Take your tank tube and put it through the bottom (the flat side) of the adapter.
  • Put the assembly in the tank
  • Close with the funnel. When you shake their should be very little play

How to load :

  • In your darkroom/bag remove the film from the holder and make sure that you know which side has the emulsion.
  • Bend the film on the LONG side so that it forms a tube with the emulsion on the INSIDE.
  • Bring the film to the adapter and, with the help of your second hand, guide it through one of the hole.
  • Rotate the adapter and repeat.

Development is done at standard speed and agitation in the tank according to your developer

The fit is quite tight on the tube, to get it out I use the agitator bar that comes with the tank

 

Print recommendation :

In your slicer, add extra perimeter and solid top and bottom layer to make the print waterproof. I printed mine at 0.2 layer height with a 0.4mm nozzle with 4 top and bottom layer as well as 4 perimeter. It helps if your first layer is very tight (no gab) same goes for the top layer.

Infill does not really matter but should be enough to have a gapless top layer (~ 20% worked for me)

I printed out of PETG because i knew it would do well in the chemicals (I do not use dangerous or corrosive chemicals but just to be sure).

 

Additional notes : 

The adapter allows to cover more or less ALL the 4 films using only 500ml of solution wich is a very practical number to calculate how I can reuse my developer : 

4 sheet of 4x5 = 1 135 roll. If i prepare 500ml of solution I can easily know how much I can get out of it and how and when i should increase time to compensate for the developer being depleted.

 

So long that you don't leave the film for very long time and that the play between the adapter and the funnel is minimal, their should be no visible sign of film being bent.

 

I have attached the freecad file in case you need to modify the adapter in any way.

Tags