Wall mount rectangular tuya zigbee wifi Temperature Humidity Sensor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Can be used to mount a temperature/humidity sensor in a dry box or printer enclosure for instance
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 37
- Makes
- 0
- Views
- 273
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I've recently started my journey down the 3D printer rabbit hole, and have since acquired more than 4 spools of filament. Because of that I needed dry boxes, and because of that I needed humidity sensors.
Because I wanted them integrated into Home Assistant and not just my eyes, I went on a search for them, and tested out a couple of zigbee and wifi models.
I'm a fan more of the AAA batteries than cell battery (CR2320 or CR2450 and the like) models. I decided in favour of the “tuya” TS0201 chip which identifies as _TZ3000_fllygh (this can still be either AAA or cell battery btw) which came with double-sided sticky pads, pretty much full size of the sensor body.
I planted them with said stickers into the dryboxes and called it good. However, after a week or so one became unresponsive and I needed to get it back out… Lo and behold, that sticker was so good (and bone dry, pros and cons), I could only get the sensor off by ripping apart the sticker… Aliswiftness can never catch a break, complaints, complaints, complaints…
Anyway, since then the sensors have been living on the bottom of the dry boxes which also isn't good!
So, I went looking for holders for them, but for the life of me I couldn't find any!? Only mounts the non-networked ones, or circular sensors ruled supreme?!
I popped my cherry, jumped into TinkerCAD and made my own.
- The sensor body is a snug fit; can be mounted sideways or even upside down I guess?
- No supports needed
- The sensor opening (bottom) is not obstructed
- The LED indicator (front) is not obstructed
- The reset-button is not freely accessible, it's on the inside of the sensor body, next to the batteries
- The accompanying sticker can be cut in half and used elsewhere!
Pretty damn proud of that :)
I think I did my best to keep filament usage to a minimum without becoming flimsy. Use it as a purge object when multicolor printing or print it with leftovers. :)
P.S. Seeing that this my first ever design plus my first upload on this beautiful platform: Comments and criticism are very welcome, but be gentle? ;-)