1 / 4
Latch / Verschluss
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Hi,
i designed this latch because the other latches on thingivers are in my opinion not strong enough for my use.
printed with PLA, 0,15 layerhigh and 80% infill
PLS POST A MAKE IF YOU PRINTED IT and tell me if it works good for you :D
Print Settings
Resolution:
0,15
Infill:
80
Notes:
print with support! But you can print the holes without support. the support at the holes is hard to remove and without supports the holes looks good too
Category: 3D Printing