Dremel 4000 Wall mount with drill tool bits storage
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dremel 3000/4000 Wall mount with Expansion options
- Rating
- 4.818 / 5
- Likes
- 1,557
- Downloads
- 3,548
- Makes
- 19
- Views
- 18,217
- Reviews
- 22
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Dremel 4000 Wall mount with drill tool bits storage. The Dremel tool can be stored either way up/down depending on your preference.
An additional section can be printed to expand your wall mount if required and can be mounted to the right and/or to the left of the Main unit.
Prints without supports.
(Will require 6mm x 2mm strong magnets)
I have added some tabs that can be used to glue into place of magnets if you prefer something more permanent.
(There is a separate file for a Dremel 3000 which is untested by me as I don't own one. Feedback welcomed)
*Update: Peg Board adaptors have been added. These are untested as I don't have a Peg Board. You will need to screw them into the Main wall mount at the top and also add the spacers at the bottom.
**Update: Dremel original case holder Extension. To be attached to the Left side. Can be mirrored in Slicer to attach to the right if preferred. I would recommend gluing this one on as it could be a bit too heavy for the magnets alone. (Print using Brim as surface contact is low)