Dremel 4000 Wall mount with drill tool bits storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dremel 3000/4000 Wall mount with Expansion options
- Ocena
- 4,818 / 5
- Polubienia
- 1552
- Pobrania
- 3531
- Wydruki
- 19
- Wyświetlenia
- 18 154
- Oceny
- 22
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Dremel 4000 Wall mount with drill tool bits storage. The Dremel tool can be stored either way up/down depending on your preference.
An additional section can be printed to expand your wall mount if required and can be mounted to the right and/or to the left of the Main unit.
Prints without supports.
(Will require 6mm x 2mm strong magnets)
I have added some tabs that can be used to glue into place of magnets if you prefer something more permanent.
(There is a separate file for a Dremel 3000 which is untested by me as I don't own one. Feedback welcomed)
*Update: Peg Board adaptors have been added. These are untested as I don't have a Peg Board. You will need to screw them into the Main wall mount at the top and also add the spacers at the bottom.
**Update: Dremel original case holder Extension. To be attached to the Left side. Can be mirrored in Slicer to attach to the right if preferred. I would recommend gluing this one on as it could be a bit too heavy for the magnets alone. (Print using Brim as surface contact is low)