50mm Marzocchi Fork Seal Slide Hammer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
4 Piece 50mm Marzocchi Fork Seal Slide Hammer for seating your new fork seals.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 136
- Makes
- 0
- Views
- 917
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
50mm Fork Seal Hammer for seating your new fork seals for a Ducati Hypermotard 1100 Evo.
Plenty of other bike models run these forks.
2 piece shell of the slide hammer is held in place by the 2 rotating collar lugs. This slide hammer can be installed and removed with forks assembled.
PETG with 100% infill recommended, however 70% appears to work fine too. Don't forget to print with supports at 0.2 (detachable).
Depending on support settings and PETG used a screw driver may be needed remove the lower supports to ensure smooth collar lug movement. Light sanding of the collars on the edges will aid if it's an interference fit.
Enjoy your re-build and stay upright.