13 models
Chamferless 1/2in drive sockets designed to fit damper and air spring top caps on mountain bike suspension forks. This set includes common sizes for Fox, Marzocchi, and Rockshox forks. For reference, the 26mm socket printed with Prusament…
A little bigger than 26mm because I had tolerance problems, exact size in the pictures. Hope you find this helpful and save about 30€.
50mm Fork Seal Hammer for seating your new fork seals for a Ducati Hypermotard 1100 Evo. Plenty of other bike models run these forks. 2 piece shell of the slide hammer is held in place by the 2 rotating collar lugs. This slide hammer can…
Use with original hexagonal rod. Use PETG, ASA, Nylon…
It is neccesary to add print pauses to change fillament colors, unless a multi color printer is used. ironing is reccomended. Ender 3 V3 SE, 0.4mm nozzle Generic PLA @ 215c
Adjuster knob for Marzocchi 888 RC3. Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 Plus Rafts: Doesn't Matter Supports: Yes Resolution: 0.15 Infill: 60 Filament: Steon PLA Category: 3D Printer Parts
Marzocchi 380 C2R2 Rebound knob Category: DIY
Marzocchi 380 C2R2 Low knob. Updated version: Body1 marzzz27.stl Category: DIY
Rebound knob for the Marzocchi Bomber Z2 fork. Model shown was printed in ASA with 3 walls. I recommend adding some Loctite to the screw. Parts needed: M3x4x5 Heatset M3x8mm Screw Loctite
Fork vise jaws for Marzocchi upside down fork as fitted on Triumph Speed Twin 1200 (2021-2024) 2 holes : one vertical, the other at an angle of 20 degrees. 53mm upper tube You can use 6 10x3mm magnets.
Inner plastic ring of the tube support which is attached to some Marzocchi motorbike suspension forks. It can be used as brake tube support or speedometer cable support. This ring is to be inserted into the metal hook-like support…
Fork vise jaws for Marzocchi upside down fork as fitted on Triumph Speed Twin 1200 (2021-2024) 2 holes : one vertical, the other at an angle of 20 degrees. 53mm upper tube You can use 6 10x3mm magnets.
Rebound knob for the Marzocchi Bomber Z2 fork. Model shown was printed in ASA with 3 walls. I recommend adding some Loctite to the screw. Parts needed: M3x4x5 Heatset M3x8mm Screw Loctite
