1 / 3
3D Druck Abteilung Schild (also in English) — image 1
1 / 3

3D Druck Abteilung Schild (also in English)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€1.72 – €2.11 net (excluding VAT)

For file: 50% scale and 2x colorchange (EN) / ps-3d-druck-schild_en_02mm_pla_mk3s_2h1m.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €1.92 excluding VAT (range midpoint).

Weight reported by the author
22 g
Print time reported by the author
2.01 hr
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

3dimensional warning sign for the 3D printing department private or in the company. also printable with Single Extruder.

Rating
4.545 / 5
Likes
110
Downloads
479
Makes
13
Views
2,866
Reviews
11

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

+++ENGLISH BELOW+++

 

3dimensionales Warnschild für die 3D Druck-Abteilung privat oder in der Firma.
auch mit Single Extruder Druckbar.

Für den Druck beachten:
Alle Teile einzeln slicen aber in der richtigen Höhenpostion.

Bei dem Düsen Modell sollten mindestens für die ersten mm im Druck ein Z Hop von ca. 10mm eingestellt werden, damit der Drucker nicht gegen den Schwarzen Rahmen des Schildes fährt.
Die Dateien sind durchnummeriert und müssen in dieser Reihenfolge gedruckt werden!


ACHTUNG: Der Startpunkt von dem Düsen Modell liegt niedriger als die höchste Kante des Schwarzen Rahmens! KOLLISIONSGEFAHR!

+++++++++++++++++++++++++++++++++++++++++++++++

3dimensional warning sign for the 3D printing department private or in the company.
also printable with Single Extruder.

For printing note:
Slice all parts individually but in the correct height position.

For the nozzle model should be set at least for the first mm in the print a Z Hop of about 10mm, so that the printer does not drive against the black frame of the sign.
The files are numbered and must be printed in this order!


ATTENTION: The starting point of the nozzle model is lower than the highest edge of the black frame! DANGER OF COLLISION!

 

Tags