Micro Swiss NG Linear Rails 5015 RHD Fan Shroud
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
MicroSwiss NG Linear Rails Fan Shroud mixed up with RHD Duct Rev. C
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 22
- Makes
- 0
- Views
- 242
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I was wondering how to improve the part cooling with the Micro Swiss NG. Since I modded my Ender 5 Pro to a Hybrid Core XY (thanks to the Endorphin3D Project ) with linear rails, it would allow me to mount the part cooling fan behind the extruder and the x-strut. This should also distribute the weight a bit better to the middle of the strut.
I did a rather heavy rework to the Micro Swiss NG fan shroud, removed the part cooling and mixed it up with the MK3 RHD Fan Duct Rev. C, since I think Roy Henriksson really did a great job on the duct details.
To fit into my Ender 5 Pro, I also had to lower my guide rod brackets, so I created drop brackets very similar to the Mercury ZeroG ones.
In the end this is a very special mod to the Micro Swiss NG extruder, but anybody using it with linear rails on an Ender 5 can try it, on a Plus or on other printers you even may not have to use the drop brackets.
Update 2025-02-01: Added missing notch on top left of the fan shroud (for extruder motor screw head).
Update 2025-01-31: Added more clearance between heat block and fan shroud.
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament:
Redline ASA-X Black
Notes:
I printed the Shroud and Duct with ASA-X. For the Fan Bracket I used PLA+.
Supports are only needed for the Fan Shroud.
Post-Printing

Drop brackets for the guide rods
When mounting the guide rod brackets you need to lower the guide rods about 15mm as shown on the picture above - just so far that there a still a few millimeters between the rods and the bottom.
Mounting
I designed the RHD mod for M3 threaded inserts so you will need three of them, where two go into the RHD mod facing the shroud:

The RHD mod needs to be fixed using M3x8 screws.
One further threaded insert goes into the fan bracket end facing the blower:

The fan bracket needs to be fixed with two M3x8 screws onto the linear rail block and the blower needs to be mounted with a M3x20 screw.
Category: 3D Printer Parts