1 / 4
Micro Swiss NG Linear Rails 5015 RHD Fan Shroud — zdjęcie 1
1 / 4

Micro Swiss NG Linear Rails 5015 RHD Fan Shroud

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

MicroSwiss NG Linear Rails Fan Shroud mixed up with RHD Duct Rev. C

Ocena
0 / 5
Polubienia
6
Pobrania
22
Wydruki
0
Wyświetlenia
242
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I was wondering how to improve the part cooling with the Micro Swiss NG. Since I modded my Ender 5 Pro to a Hybrid Core XY (thanks to the Endorphin3D Project ) with linear rails, it would allow me to mount the part cooling fan behind the extruder and the x-strut. This should also distribute the weight a bit better to the middle of the strut.

I did a rather heavy rework to the Micro Swiss NG fan shroud, removed the part cooling and mixed it up with the MK3 RHD Fan Duct Rev. C, since I think Roy Henriksson really did a great job on the duct details.

To fit into my Ender 5 Pro, I also had to lower my guide rod brackets, so I created drop brackets very similar to the Mercury ZeroG ones.

In the end this is a very special mod to the Micro Swiss NG extruder, but anybody using it with linear rails on an Ender 5 can try it, on a Plus or on other printers you even may not have to use the drop brackets.

Update 2025-02-01: Added missing notch on top left of the fan shroud (for extruder motor screw head).

Update 2025-01-31: Added more clearance between heat block and fan shroud.

 

Print Settings

Printer Brand:

Creality

Printer: 

Ender 5

Rafts:

No

Supports: 

Yes

Resolution:

0.2

Infill: 

20%

Filament:

Redline ASA-X Black 
 

Notes: 

I printed the Shroud and Duct with ASA-X. For the Fan Bracket I used PLA+.

Supports are only needed for the Fan Shroud.

 

Post-Printing

Drop brackets for the guide rods

When mounting the guide rod brackets you need to lower the guide rods about 15mm as shown on the picture above - just so far that there a still a few millimeters between the rods and the bottom.

 

Mounting

I designed the RHD mod for M3 threaded inserts so you will need three of them, where two go into the RHD mod facing the shroud:


The RHD mod needs to be fixed using M3x8 screws.

One further threaded insert goes into the fan bracket end facing the blower:

The fan bracket needs to be fixed with two M3x8 screws onto the linear rail block and the blower needs to be mounted with a M3x20 screw.
 

Category: 3D Printer Parts

Tagi