Dart holder for MMU / single extruder available
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dart holder wall mountable MM and single extruder available
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 51
- Makes
- 0
- Views
- 423
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
I uploaded an old file but have uploaded the correct one (pointed out by a user :))
Visually based on model 1167828.
Complete redo from scratch. This version for MMU. Uses key holes for hanging,(#6 screws).
Load as project if you want to make changes. IE type of infill, percentage, supports, filament type resolution.
The holes for the darts hay have some debris in them run a small drill bit (2.4mm) in the hole
I have included a template for hanging/mounting. Place in desired location. Use a pin in top center hole. Let it swing (will level on its own, you may be required to clean out hole depending on your pin) Now mark the other 2 holes and drill the correct pilot hole size. put in screws most the way in. Now hang the print. I have printed in PLA and PETG with good results. There is a single extruder version as well at:
www.printables.com/model/1172120