Prusa XL Enclosure Front Conduit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Conduit to route wires across the front of the XL Enclosure
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 33
- Makes
- 3
- Views
- 547
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
I added a second LED strip to the left-side of the enclosure and needed a way to power it. Easiest way was a short connector from the right-hand LED strip across to the left. I didn't really like the cable anchors and zip ties for this since it is right there when you open the door and was an eyesore. So this is a conduit to hide the wire as it crosses the front of the enclosure.
It is designed to snap onto the ends of the four protruding top hinge screws. Place over the screws with the conduit pulled toward you then, while holding it snug, push toward the back - snapping it onto the bolts.
I printed in PETG in EXT1 and using PLA for supports in EXT5. It is a bit of a bed adhesion torture test due to the long length and relatively small footprints on the ends so I added a brim to ensure it adhered. May not have been necessary but brims are a cheap and easy insurance against this.