Wall Control Guitar / Ukulele Hanger
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fits sheet metal pegboard with 1/4' x 1" hole grid. Tested with Wall-Control. Not compatible with thicker peg boards.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 11
- Makes
- 0
- Views
- 285
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Share Alike
A pegboard instrument hanger compatible with thin pegboards using a 2.54mm (1") grid. Tested with Wall Control panels. Not likely compatible with old-school press-board panels due to the thickness of the pegboard.
Print with the following specs (or better) with a focus on strength and durability:
- 0.2mm layer height
- force .4mm extrusion width
- 40% infill, 4 perimeters
- 5 top/bottom layers
WARNING: Test to make sure this can support the weight of any instrument you hang from it before using it. Don't use it if there is any doubt.
SUPPORTING YOUR FAVORITE DESIGNERS:
If you like this, consider using one off the affiliate links below to buy your next roll of filament. Or just to get to Amazon. ‘Likes’, ‘Follows’ and ‘Downloads’ are also appreciated.
BOM:
- Filament:
- PLA+: https://amzn.to/3CEHMk0
- ABS: https://amzn.to/3X3hUVO