Helldivers Helmet/Skull (display)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Helldivers Helmet display for your shelf / setup (12cm high).
- Rating
- 5 / 5
- Likes
- 154
- Downloads
- 691
- Makes
- 5
- Views
- 3,139
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Standard Digital File License
! The model shown in the picture was painted !
Already print-ready. The parts need to be glued together, while the connector helps to find the right position for gluing.The print plate model is a bit tricky to clean up and there will be a seam line down the middle, which you can fill with pollyfilla and coat it with a primer to make it less to none visible.You can also try to slice the raw helmet by tilting it on the chin at an angle, to print the helmet as a whole piece, but the risk of the print failing will be higher.
If you find a better way to slice the helmet without a noticeable seam line, you can share it in the comments.
Recommeded settings:
- 0,08 layer hight / high quality
- tree supports
- seam position: random