Woodturning Vase 07

Based on the Woodturning Bowl 05 I've created these vases. You might also call them "The Bomb" or "Mind bender" ;-)

The base pattern is a simple hexagon where every 2nd corner is connected to the center.

The resulting profiles are extruded into single colors and than patterned along the dotted lines.

If you like this little thing, you might want to check those ones, too:

https://www.prusaprinters.org/social/3373-wilko/collections/36089

Print Settings

Notes:

Both vases do need some support from the build plate but not internally.

Depending on your settings this is a long print. Be prepared for a 8 to 9 day print if you're going for 0.2mm layer height and 0.4mm extrusion width.