1 / 3
Raspberry Pi Zero / Zero 2 W Case Bottom Dust Cover (Non-GPIO Models)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple bottom dust cover for the original Raspberry Pi Zero case (for boards with an unpopulated 40-pin GPIO connector).
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 18
- Makes
- 0
- Views
- 161
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This piece will cover the bottom opening of the original Raspberry Pi Zero Case (only fits if GPIO connector is unpopulated). The collar is about 0.3-0.4 mm thick and will fit underneath the board.
Printed in PLA, 0.1 mm layer height, 100% infill, no supports.
The slicer should generate 3-4 layers for the collar.
Carefully remove from the print bed. Detach plate if possible, let it cool, then gently bend it to pop the piece off.