1 / 9
Prusa Core One top cover mod - handle and holder version 2 — image 1
1 / 9

Prusa Core One top cover mod - handle and holder version 2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

For easy handling of the top cover and storing it behind the printer. Parts includes a handle, corner hooks and a frame.

Rating
4.684 / 5
Likes
537
Downloads
1,022
Makes
26
Views
9,615
Reviews
19

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

If you want better access to the printer head and the inside of the Core One, you can unscrew the top cover. However, this cover is difficult to handle and store temporarily.

So this will solve that. 

There are three main pieces, you don't need to print all at once. 

One piece replaces the sliding vent cover and adds a handle to it for easier lifting. This alone will make it easier for many to handle and set the cover aside. The vent cover is smaller to fit on the printer's printing surface, but is still functional and will cover all holes when moved.

The other part - hook - prints twice and attaches to the back top edge of the printer. This double part for the left and right side is connected by a small pin (third part) for added strength inside. On the printer itself, it is held in place by screws with locknuts in pre-existing holes on the printer. The design assumes 3 mm Allen head screws at least 2.5 cm long.

Disclaimer: unscrewing the top cover lowers a little bit the stiffness of this printer, but no problems were discovered so far. 

If you want the full experience and fasten the printer body, you can print the frame consisting of four parts - Front Left, Front Right, Back Left, Back Right. 

Screw it with original black screws from the printer and add 3 mm Allen head screws at least 1.5 cm long with locknuts in the middle of the sides.

For the color coding you should choose Prusa3D orange for the top cover (your hands touch it) and black (Galaxy Black) for the hooks and the frame (structural body).  Even without MMU you can print black base, pause and replace color and finish the handle in orange.

I prefer to print the hooks on the side with the brim enabled, because the bottom layer is just a line. However, no supports are needed and the brim is easily removable with a knife. Plus, this bottom layer can point backwards when placed on the printer, hiding any cosmetic mistakes when removing the brim.

Tags