Flipper Zero Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
A case for the Flipper Zero, using the foam inserts that come with the package. No additional hardware is required, just a bit of filament for the hinge. It also features pockets for 6mm x 2.6mm (usually sold as 3mm) magnets but it'll probably be fine without them.
For the magnets, use your preview to find the layer where it covers up the magnet pockets and add a pause before printing that layer. Insert your magnets and resume, and you'll be good to go. The pockets are labeled “A” and “B” to help you put the magnets in the right orientation.
After printing each part, run some filament through the hinge to make sure there are no obstructions, then put the pieces together and lock them together with filament. Trim the ends (tip: after trimming one side, you can pull the other side out a bit and trim it before pushing it in so neither end sticks out) and your box is complete. The filament should just stay in there by itself (no glue or anything needed) but if it starts to come out just push it back in.