Magnetic Print Sheet Holder - Prusa CORE One
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.73 – €3.34 net (excluding VAT)
For file: prusa-core-one-sheet-holder_0.4n_0.25mm_PETG_COREONE_2h29m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.03 excluding VAT (range midpoint).
- Weight reported by the author
- 53 g
- Print time reported by the author
- 2.48 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Print sheet holder using 6x3mm magnets (common in Voron projects). Fits 3 sheets
- Rating
- 4.9 / 5
- Likes
- 302
- Downloads
- 1,212
- Makes
- 43
- Views
- 6,673
- Reviews
- 40
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
Prusa CORE One Print Sheet holder
Simple magnetic print sheet holder for your Prusa CORE One. This model uses 6x3mm magnets commonly found in Voron projects.
This model fits 3 Prusa print sheets.
Check out the remixes for different magnet sizes and fits!
Required hardware
- Six 6x3mm magnets minimum. If you're using weaker magnets, like I am, there are extra holes for magnets to help keep it solid. I used 14 magnets in total. You can use fewer N52 magnets.
Print Settings
- PETG
- Stock 0.4mm HF nozzle
- 0.25mm layer height
- Add a height range modifier to set 0.1mm layer height after 12mm to reduce stair stepping effect
- To do this, right click on the STL in the slicer and click on Height range modifier
- On the right side set the start height to 12mm and the end height to 20mm with a 0.1mm layer height
- A bed adhesive may be required to help keep it from warping
Assembly instructions
- Press fit the magnets into the holes. Glue is optional. The magnets should fit in very tightly
- If your magnets are undersized, you may need an adhesive like CA glue.
- Install in the left compartment of your Prusa CORE One
Update 2025-03-07: Updated STL and STEP to have more consistent holes and added models with looser hole tolerances