1 / 2
Magnetic Print Sheet Holder - Prusa CORE One
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print sheet holder using 6x3mm magnets (common in Voron projects). Fits 3 sheets
- Ocena
- 4,9 / 5
- Polubienia
- 302
- Pobrania
- 1212
- Wydruki
- 43
- Wyświetlenia
- 6668
- Oceny
- 40
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 43) (Komentarze: 48)Remiksy (4)Kolekcje (702)Powiązane
Prusa CORE One Print Sheet holder
Simple magnetic print sheet holder for your Prusa CORE One. This model uses 6x3mm magnets commonly found in Voron projects.
This model fits 3 Prusa print sheets.
Check out the remixes for different magnet sizes and fits!
Required hardware
- Six 6x3mm magnets minimum. If you're using weaker magnets, like I am, there are extra holes for magnets to help keep it solid. I used 14 magnets in total. You can use fewer N52 magnets.
Print Settings
- PETG
- Stock 0.4mm HF nozzle
- 0.25mm layer height
- Add a height range modifier to set 0.1mm layer height after 12mm to reduce stair stepping effect
- To do this, right click on the STL in the slicer and click on Height range modifier
- On the right side set the start height to 12mm and the end height to 20mm with a 0.1mm layer height
- A bed adhesive may be required to help keep it from warping
Assembly instructions
- Press fit the magnets into the holes. Glue is optional. The magnets should fit in very tightly
- If your magnets are undersized, you may need an adhesive like CA glue.
- Install in the left compartment of your Prusa CORE One
Update 2025-03-07: Updated STL and STEP to have more consistent holes and added models with looser hole tolerances