1 / 5
Sony WH-CH500 bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement bracket for WH-CH500 (tested only for this; might work for similar models)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 40
- Makes
- 0
- Views
- 250
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution
Replacement Bracket for WH-CH500 (tested only for this model; might work for similar models)
- The Bracket folder contains files for the piece without the connected part.
- The Bracket Whole folder contains files for the piece with the connected part to replace the entire section of the headphones.
Post-Print Instructions for Bracket Whole print:
- Remove the custom support structures labeled “remove” (these supports are necessary for print stability).
- Sand any leftover material if needed.
- Twist the main part 360 degrees to break the custom supports under the connection point/wire hole.
Additional Hardware for Bracket Whole print:
- 2x M2x8 screws are required to connect the cover and main parts.
Refer to the screenshots for recommended print settings and support placement.