1 / 5
Sony WH-CH500 bracket
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement bracket for WH-CH500 (tested only for this; might work for similar models)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 250
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
Replacement Bracket for WH-CH500 (tested only for this model; might work for similar models)
- The Bracket folder contains files for the piece without the connected part.
- The Bracket Whole folder contains files for the piece with the connected part to replace the entire section of the headphones.
Post-Print Instructions for Bracket Whole print:
- Remove the custom support structures labeled “remove” (these supports are necessary for print stability).
- Sand any leftover material if needed.
- Twist the main part 360 degrees to break the custom supports under the connection point/wire hole.
Additional Hardware for Bracket Whole print:
- 2x M2x8 screws are required to connect the cover and main parts.
Refer to the screenshots for recommended print settings and support placement.