Pousa v4 - Phone stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My take on yet another phone holder for my own specific needs, but you might like it too. Now in v4.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 32
- Makes
- 0
- Views
- 113
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Pousa (“Put it down”) v4
My take on yet another phone holder for my own specific needs, but you might like it too. Now in v4.
⚙ Considerations:
🔻 Good handling - 20 degrees angle ergonomic design
🔻 Print to strenght ratio - Lowest material rate to strenght.
🔻 Size - extremely compact, enabeling you to put it against a wall without it needing much space;
🔻 Supports for who? - printing it either verticaly or horizontaly it requires few supports
🔻 Gadget - Lil separate part for better vertical charging no need to compromise strenght, balance or use cases. It can be stored “backwards” on the inside of the stand.
🔻 For everyone - From phones 4" to Ipad Pro 12.9" (without vertical support) it can handle every gadget size.
🔻 Print time - around 2h depending on your settings… my gcode is for good bridging but use .stls if you want to test prefs.