1 / 3
Cover for terminals on Blue Sea ML Solenoid — image 1
1 / 3

Cover for terminals on Blue Sea ML Solenoid

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Cover for terminals and wire lugs for Blue Sea ML series Solenoids, mine is the 7701, but any of the ML series

Rating
0 / 5
Likes
2
Downloads
6
Makes
0
Views
70
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted to cover the terminals/lugs on my Blue Sea ML 7701 Solenoid, as they were left exposed, to minimize possible random risk. Extremely unlikely, but just in case. The solenoid is installed horizontal, and Blue Sea said that's OK as long as it's not upside down.

My main cables are 2/0 AWG, with the one on the left angled up slightly, so that opening is a bit taller. 

This has 4 screw down points for #8 pan head screws, and 2 spots for small zip ties for helping to organize the control wires. 

Printed in eSun PLA Basic in Red, 25% infill (not a lot of infill anyways, upside down to minimize supports. I would prefer ABS, but I only had Red in PLA, so went with that for now. Walls are ~2mm, so fairly sturdy, and given how unlikely it is to have any debris where I have it, I'm not worried. If it was in a compartment with more stuff, I'd definitely end up printing in ABS. 

Tags