Spare steel sheet holder wall mount for adhesive strips
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix for single steel sheet wall mount to hang with adhesive strips (with wedges to access strip for removal)
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 38
- Makes
- 1
- Views
- 364
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
Description
This is a remix of G.wrks Spare steel sheet holder wall mount (thanks a lot!). It removes the screw holes for mounting with adhesive strips. It also adds wedges at the back that make the strip ends accessible after mounting. I have used Tesa Powerstrips (small) to mount, pulling on the accessible ends enables to remove the wallmount again (tested).
I have also added a longer version that can hold the steel sheet horizontal (font of sheet properly oriented). With the removed parts this fits just fine. It's a matter of taste so pick which one you prefer. The wall mount photo shows the horizontal version, there is also a photo showing them side by side (front and back with wedges, models contain the smaller wedge of 10mm height).
Print Instructions
I have printed this with PETG. There is a considerable amount of stringing which must be removed afterwards (on the second print I reduced travel speed tp 130mm/s and Retraction Speed to 40mm/s, got a little better but not a lot). PLA might yield better results but I haven't tried that myself. Like G.wkrs model this is properly oriented to print.
| Printer | MK3s+ |
| Filament | Prusament PETG |
| Infill | 25% |
| Supports | None |