Shaper Origin spindle light (USB)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
USB light that fits on the spindle (gen1 or gen2)
- Rating
- 5 / 5
- Likes
- 30
- Downloads
- 98
- Makes
- 1
- Views
- 1,041
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
A simple USB light to fit directly on the Shaper Origin spindle.
I used two superbright LED and the Origin USB-C port (with an adapter) to power it.
--Some basic soldering skills are required--
Printing Instructions:
Material: ASA (recommended, PETG should work as well)
Infill: 100%
Supports: NO
Slow down the speed!
Hardware:
n.1 M3 bolt and nut
n.2 squared LED superbright (7,5x7,5mm). If you want to buy these look for LED 5mm piranha.
n.2 100 Ohm resistors (1/4W)
Optional: a USB-C to USB2.0 adapter, see picture (or you can use a USB-C cable directly)
Soldering Instruction:
LEDs needs to be soldered in parallel, so, for each LED:
+ to the resistor, then to the anode (led+)
- to the cathode (led-)
I also attached the .step file in case you want to use different hardware or made some changes.