Shaper Origin spindle light (USB)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
USB light that fits on the spindle (gen1 or gen2)
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 98
- Wydruki
- 1
- Wyświetlenia
- 1041
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
A simple USB light to fit directly on the Shaper Origin spindle.
I used two superbright LED and the Origin USB-C port (with an adapter) to power it.
--Some basic soldering skills are required--
Printing Instructions:
Material: ASA (recommended, PETG should work as well)
Infill: 100%
Supports: NO
Slow down the speed!
Hardware:
n.1 M3 bolt and nut
n.2 squared LED superbright (7,5x7,5mm). If you want to buy these look for LED 5mm piranha.
n.2 100 Ohm resistors (1/4W)
Optional: a USB-C to USB2.0 adapter, see picture (or you can use a USB-C cable directly)
Soldering Instruction:
LEDs needs to be soldered in parallel, so, for each LED:
+ to the resistor, then to the anode (led+)
- to the cathode (led-)
I also attached the .step file in case you want to use different hardware or made some changes.