1 / 2
Simple Superlux E205U stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stand included with microphone takes quite a lot of space, so I made it smaller.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 60
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution
Required hardware:
- 2x20mm M3 caphead bolts
Printed parts:
- 2x "ring"
- 1x “body left”
- 1x “body right”
Recommended print settings:
- 20% adaptive cubic otherwise might be too flimsy
- no brim required
- “ring” should be printed with arch pointing up
- left and right side of the body should lay flat on the bed with mating surfaces upwards
- supports for “ring”
I printed mine from Sunlu PLA+ 2.0 on Qidi Q1 Pro.
Assembly notes:
Since this is not often disassembled I went with directly cutting threads into the plastic. If needed holes in body left can be filled with heat inserts, but I don't see the point in using them.