Smartphone and Apple Watch charging wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A wall mount for holding two phones and an Apple watch. It is approx. 25 cm wide and 16 cm high.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 15
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple wall mount for holding phones and/or an Apple watch for charging. For the Apple watch it has a bed that fits the charger perfectly. One phone can stand upright, another can either stand upright or lay on the side (cable hangs out to the side of the mount then). The model can be mirrored.
I printed it in an upright position with supports only in one place (see picture from Creality slicer). The overhanging slope of the watch holder doesn't come out very clean without supports, but for me it was good enough.
Since this model doesn't have to withstand any higher forces PLA is totally enough.
You can adapt the design to your liking with the enclosed F360 archive file (not parametric, just edit the features directly).