1 / 6
Silicgel box (about 45g of silica gel)-v1.0
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A box that can hold about 45g of silica gel
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 73
- Makes
- 1
- Views
- 258
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The box can hold approximately 45g of silica gel.
It has a locking mechanism to prevent the lid from falling off.
To open, a fingernail or tool is needed to lift and remove the lid.


Very important
slicer setting
I printed with PETG
Wall loops: Set to 3.
Top shell layers: Must be set to 0 layers.
Bottom shell layers: Must be set to 0 layers.
Sparse infill density: Set to 30%.
Sparse infill pattern: Cross Hatch or Rectilinear

By strictly following these red-boxed settings, you should achieve a successful and accurate print.

2025/02/24
Improved ease of opening the lid