High Bypass Jet Engine Fan w/ Display Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Display your fan and spin it on 608 size bearings
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 106
- Makes
- 0
- Views
- 883
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial
This is a complex print that requires good bed adhesion and tight tolerances. Supports required on the Annulus Fillers and Fan Disk. You will need 19 Annulus Fillers and 19 Fan Blades.
BOM:
- 4x 3x6 magnets to hold spinner on to hub
- 2x 608 bearings
- 1x ¼" x 3" or M6 x 70mm bolt (shorter may work)
Notes from the original model:
The white spiral stripe is printed flat and glued onto the black spinner cone. If the stripe is too rigid, I recommend printing it with fewer layers (so it's thinner), or softening it with a heat gun or hot water, or printing it with flexible filament.
Be careful about where the slicer assigns the layers start seam, especially for the fan blades - I recommend placing the seam at the fan blades' trailing edge.