RatRig V-Core 3.1 & 4 Bottom Clip for 1"/25mm PIR
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds 1"/25mm thick PIR insulation to the underside of a 3030 extrusion based printer like the RatRig V-Core 3.1 & 4
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 23
- Makes
- 1
- Views
- 294
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Uses an M6x12 and M6 3030 T nut to install underneath a V-Core 3.1 or 4.
Designed for 1 inch or 25mm thick PIR (also called Polyiso or polyisostyrene). STEP filed provided if you would like to adjust it for different thicknesses.
These are designed to compress the PIR somewhat when tightened down. As such, the printed part will likely flex some when installed. I suggest using a material, like ABS/ASA, that will tolerate that flex. Too stiff of a material (CF/GF filaments, PET-CF, PPS-CF, PPA-CF, etc) will likely just puncture your PIR instead of holding it nicely in place.