1 / 1
RatRig V-Core 3.1 & 4 Bottom Clip for 1"/25mm PIR — zdjęcie 1

RatRig V-Core 3.1 & 4 Bottom Clip for 1"/25mm PIR

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holds 1"/25mm thick PIR insulation to the underside of a 3030 extrusion based printer like the RatRig V-Core 3.1 & 4

Ocena
5 / 5
Polubienia
10
Pobrania
23
Wydruki
1
Wyświetlenia
293
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Uses an M6x12 and M6 3030 T nut to install underneath a V-Core 3.1 or 4.  


Designed for 1 inch or 25mm thick PIR (also called Polyiso or polyisostyrene).  STEP filed provided if you would like to adjust it for different thicknesses.

These are designed to compress the PIR somewhat when tightened down.  As such, the printed part will likely flex some when installed.  I suggest using a material, like ABS/ASA, that will tolerate that flex.  Too stiff of a material (CF/GF filaments, PET-CF, PPS-CF, PPA-CF, etc) will likely just puncture your PIR instead of holding it nicely in place.

Tagi