Filament Sensor for Fysetc CNC Sherpa mini Extruder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified Sherpa mini filament sensor - PC4-01 connector to fit my setup better
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 69
- Makes
- 0
- Views
- 540
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I modified "Sherpa mini filament sensor - PC4-01 connector" to fit my setup better, so though I would share. I added 8 mm shaft to replace the Metal ECAS in the Fysetc Sherpa mini CNC version Extruder. I used a 13 mm reverse bowen tube in the shaft for a snug fit.
I was seeking a solution for my ERCF v2 setup to improve the loading / unloading.
Items you will need:
- 13 mm PTFE tube
- M3 BHCS 8 mm (x1)
- 5.5 mm ball (same as used in ERCF v2) (x1)
- Microswitch D2F (same as used in ERCF v2) (x1)
- M2 BHCS 10 mm (x2)
- M3 BHCS 20 mm (x1)
- PC4-M10 Pneumatic Connector
- some wire
Items to note, the PTFE tube should stick out 2 mm past the shaft. Also do not over tighten the screws going into the K-face or the motor adjustment screw, the mounts break off.
