1 / 13
Filament Sensor for Fysetc CNC Sherpa mini Extruder — zdjęcie 1
1 / 13

Filament Sensor for Fysetc CNC Sherpa mini Extruder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified Sherpa mini filament sensor - PC4-01 connector to fit my setup better

Ocena
0 / 5
Polubienia
15
Pobrania
69
Wydruki
0
Wyświetlenia
540
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I modified "Sherpa mini filament sensor - PC4-01 connector" to fit my setup better, so though I would share. I added 8 mm shaft to replace the Metal ECAS in the Fysetc Sherpa mini CNC version Extruder. I used a 13 mm reverse bowen tube in the shaft for a snug fit.

I was seeking a solution for my ERCF v2 setup to improve the loading / unloading.

Items you will need:

  • 13 mm PTFE tube
  • M3 BHCS 8 mm (x1)
  • 5.5 mm ball (same as used in ERCF v2) (x1)
  • Microswitch D2F (same as used in ERCF v2) (x1)
  • M2 BHCS 10 mm (x2)
  • M3 BHCS 20 mm (x1)
  • PC4-M10 Pneumatic Connector
  • some wire

Items to note, the PTFE tube should stick out 2 mm past the shaft. Also do not over tighten the screws going into the K-face or the motor adjustment screw, the mounts break off.

 

Tagi