Battery holder for Baseus 65w 30k-mah battery bank, with hole for 1/4"-20 heat insert.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder (cage) for Baseus battery bank (model BS-3kP325) with hole for 1/4"-20 heat thread insert for mounting.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 23
- Makes
- 0
- Views
- 133
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought this battery for my film equipment, and it's amazing. It is capable of multiple voltage outputs simultaniuosly. It can power my wireless mic reciever (5v), my camera, (7.5v) and my external monitor (12v) all at the same time. Here's the amazon listing: https://a.co/d/i8DNIR8
I use it out in the field, and I have used a janky setup with zipties to secure it to my tripod.
No more.
I also added a hole in the back for a ¼-20 heat insert. i used these: https://a.co/d/2Q47QEy
The hole is 9mm diameter and 7.5mm deep. 0.5mm smaller than the insert, that gives enough plastic for the insert to grab onto.
The wall just behind the insert is 1 wall thick. (adding more walls won't change that). So i reccomend using something flat and metal held against the inside of the back wall to keep the insert from poking through into the inside of the cage. In my case , used a hotshoe thread adapter.

The holder (im my example, which wasnt printed on the most stable of surfaces) is a snug but good fit for the battery. If yours comes out loose, you can use some scotch tape or something to the battery to tigten it up.
Prints well on it's bottom. I juat used standard settings with PLA and haven't had a problem.
0.4 nozzle
0.2 layer
15 infill
3 walls
no supports needed.
