1 / 1
Heewing T1 Rear Hatch for DJI O3
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for stock rear hatch that can hold O3 Air Unit together with my universal upper half
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 176
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
- upper part is compatible with my mounts for atomrc swordfish and volantex phoenix 2000 v2
- 8(!) 5x5x(≤5) magnets needed, they should be as strong as possible
- press magnets inside pockets (mind correct polarity for assembly)
- clip antenna into place
- the antenna cable can be a little bit in the way when closing front hatch before flight, gently push it aside
- due to printing orientation and this being a 2-wall-print, the magnetic force isnt as strong as one would wish, but enough for flight so far
- I attached the project file for orcaslicer that I used with my creality k1c
- print in sufficiently heat resistant material
- supports needed, be careful when removing, make sure they dont block the pockets for the magnets
- advantages: modularity, simple to use
thx to @aviphysics (thingiverse) for the original model of the blank rear hatch