1 / 1
Heewing T1 Rear Hatch for DJI O3
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for stock rear hatch that can hold O3 Air Unit together with my universal upper half
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
- upper part is compatible with my mounts for atomrc swordfish and volantex phoenix 2000 v2
- 8(!) 5x5x(≤5) magnets needed, they should be as strong as possible
- press magnets inside pockets (mind correct polarity for assembly)
- clip antenna into place
- the antenna cable can be a little bit in the way when closing front hatch before flight, gently push it aside
- due to printing orientation and this being a 2-wall-print, the magnetic force isnt as strong as one would wish, but enough for flight so far
- I attached the project file for orcaslicer that I used with my creality k1c
- print in sufficiently heat resistant material
- supports needed, be careful when removing, make sure they dont block the pockets for the magnets
- advantages: modularity, simple to use
thx to @aviphysics (thingiverse) for the original model of the blank rear hatch