Cable Clip | Special Gripper | for 11A LVDC Flat LED Cable
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
► Single & Twin cable variants ► Springy internal bridges cope better with variations in cable. ► FreeCAD model
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 48
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
As if the world needed any more cable clips.
Well, here we are…
These are for low voltage 2-core cables often used in lighting. Typically they have 0.5 mm2 conductors rated at 11 Amps.
The flat (oblong?) cable jacket can actually vary a little in size. Some Tagra LED tapes sport a ‘tail’ of 4.4 x 2.8 mm section. But separately I've bought equivalent cable with a slightly thicker 5.0 x 3.3 mm section.
A drawback of most cable clips is that they don't accommodate much size variation of the cable, so either it's over-pinched, or slack.
My design has springy internal bridges that grip well on both of the cable sections mentioned above. Looking closely at the photo, the cable on the right is the thicker one.
Doubtless you could scale the clip in your slicer, to accommodate other cable sizes if required.
A FreeCAD source model is also included.
